Desa CGEFP33PRB, CGEFP33NRB, EFP33PRB, EFP33NRB Owner's Operation And Installation Manual page 15

INSTALLATION
Continued
INSTALLING THERMOSTATIC
BLOWER ACCESSORY
NOTICE: Shut off gas supply
and disconnect heater from gas
supply if installing blower in
previously installed fireplace.
Contact a qualified service per-
son to do this.
1. If fireplace screen and floor are still installed,
see Removing Fireplace Screen and Floor
Assembly, page 9.
2. Using screw provided, attach green ground
wire from speed control cord to blower hous-
ing. Tighten screw securely (see Figure 18).
3. Place the blower against lower rear wall of
firebox outer wrapper with the exhaust port
directed upward. Align the holes in top mount-
ing tabs of blower with holes in wall of wrapper
(see Figure 19). Using two #8 screws provided,
mount blower and tighten screws firmly.
4. Remove the three screws (do not discard) and
cover plate from center of firebox wrapper rear
wall. Discard this cover plate (see Figure 18).
Thermostatic Switch
and Cover Assembly
Blue Wire
Black
Wire
Speed Control
Figure 18 - Installing Switch and Cover
Assembly and Speed Control
111245-01B
Red
Wire
Green Wire
www.desatech.com 15