Table of Contents
Advertisement
PRODUCT
IDENTIFICATION
Optional Remote
Control
Control
Knobs
Piezo
Ignitor
Remote Selector
Switch (Optional)
Figure 1 - Log Base Assembly
Top Louver
Assembly
Firebox
Hood
Firebox
Support
Screen
Assembly
Figure 2 - Fireplace
104353
One Piece Log Set
Top Outer
Casing
Bottom Louver
Blower Assembly
Assembly
(Optional)
3
OWNER'S MANUAL
LOCAL CODES
Install and use fireplace with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
UNPACKING
1.
With utility knife, cut the carton all the
way around above the staples on the
bottom tray. Lift the carton off the
heater. Remove packing. Note: The
hood is located in the packing on the
right hand side of the heater front. Lift
the heater off the bottom tray.
2. Locate two screws above top corners
of the fireplace screen. Remove and
discard these screws. Lift fireplace
screen up and pull out to remove.
3. Remove protective packaging applied
to logs, log base assembly, and
fireplace.
4. Remove fireplace hood from carton
insert.
5. Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought fireplace.
REMOTE CONTROL
ACCESSORIES
There are four optional remote controls that
can be purchased separately for this log
heater:
• wall switch
• wall thermostat
• hand held ON/OFF remote
• hand held thermostat remote
See Accessories, pages 22 and 23.
1430 Broadway
Advertisement
Table of Contents
