Russound ST2 Installation Manual page 5

IR-controlled System
CA Series -
The ST2 Tuner can be controlled by infrared
commands received through the two IR connec-
tions on the rear panel. The ST2 contains two
individual tuners, which makes it act as two
sources in the CA system. There are two source
audio outputs and two IR connections - one for
each tuner in the ST2. You will need at least one
IR link cable (Russound P/N 09-0508) for these
connections. There are two unique IR code sets
for Tuner 1 and Tuner 2, which allow each to be
controlled independently from either IR connec-
tion. These codes can be learned from the ST2-
RC remote control into the CAS-RC remote con-
trol. If you are using an IR-controlled system from
another manufacturer, installation should be simi-
lar. The ST2 IR codes may be learned into many
other manufacturers' remote controls that have
learning capability for unified control over the A-V
equipment.
Note: Optional ST2-KP keypads can be used to
provide control for the ST2 Tuner and are
designed to be used with IR-controlled systems.
RS-232 Controlled System
The ST2 Tuner can be controlled using the RNET
protocol provided via the RS-232 port on the
rear panel. It can also be controlled by any
RS-232-enabled control system (e.g., Crestron,
AMX). Information on RS-232 operation is avail-
able to dealers in the Document Center on the
Russound web site, www.russound.com .
BOX CONTENTS
The ST2 Tuner comes with the parts needed to
setup and operate the component. These
include:
• ST2 Tuner (two AM/FM modules)
• ST2-RC remote control
• 12VDC power supply
• AM loop antenna (2)
• FM antenna (2)
• RCA audio cable (2)
• Rack mount ears
If any of these parts are missing, please call
Russound at 800-638-8055 ext. 501 for
assistance.
INTRODUCTION
5