Factory Initialization - Russound ST2 Installation Manual

ST2 TUNER PROGRAMMING
ST2 TUNER SETUP MENU
Press and Hold
TNR SEL button
TNR
SEL
TUNER
SETUP
Menu
Update Firmware (Chassis) (cont'd)
1. Enter the Setup Menu by pressing and holding
the TNR SEL button.
2. TUNER SETUP appears. Press MEM Up/Down
until UPDATE FIRMW appears on the tuner.
3. Press BAND to enter the UPDATE FIRMW menu.
4. "Hold BAND" appears on the tuner.
5. While pressing and holding BAND, "After
update cycle power" appears on the tuner display.
6. When "Start Update" appears on the tuner dis-
play, start the update program. "Finished" will
then appear in firmware's update window on the PC.
7. Cycle power to the tuner.
Factory Initialization (Chassis)
The Factory Initialization procedure allows the
erasure of all programmed settings and returns
22
ST2 Chassis Setup Procedures
TNR
SEL
SOURCE
UPDATE
NUM
Procedure
Procedure
TNR
SEL
TUNER
#
After update
cycle Power
SOURCE
NUM
Cycle Power
FACTORY
FIRMW INIT
Procedure
This
Procedure
HOLD
returns the
BAND
ST2 Tuner
to its
Factory
settings
Are you sure
Start
Update
YES NO
Please wait
Cycle Power
them to the factory default settings.
1. Enter the Setup Menu by pressing and holding
the TNR SEL button.
2. TUNER SETUP appears. Press MEM Up/Down
until FACTORY INIT appears on the tuner.
3. Press BAND to enter the FACTORY INIT menu.
4. "Are you sure" appears on the tuner. Using the
Tune Up/Down buttons, view the "Yes" and "No"
selections.
5. Press BAND to select. A "No" selection
returns to the top of the Factory Init menu. A
"Yes" begins the initialization.
6. "Please wait" appears on the tuner during the
process and "Cycle Power" appears when com-
plete.
7. Cycle power on the ST2 tuner.
Chassis
SYSTEM
Setup
INFO
Procedure
Menu