Maintenance; Nozzle; Brushes - Hoover F5912-900 - 5-Brush Turbo 5200 Steam Vac Owner's Manual

Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure
continued cleaning effectiveness.
Any other servicing should be done by an authorized service representative.

nozzle:

how to Clean
If lint or other debris becomes lodged in nozzle, do not attempt to remove
nozzle cover.
Pour one to two cups of clear water on a non-carpeted floor Do not pour water
onto a wood floor.
Pick up water with your SteamVac
debris is flushed out of nozzle.
Some models have a nozzle clean-out tool for removing debris.
5.1 To use the tool: Disconnect carpet cleaner from electrical outlet. Slide tool
into nozzle and remove debris as shown.
To clean the outside of the machine, wipe off dirt with a cloth dampened in warm
water and mild detergent. do not use solvent or petroleum based products
to clean the machine.

brushes:

how to Change and Clean
Your carpet cleaner is equipped with removable
brushes for easy cleaning.
CAUTION
!
To reduce the risk of injury from moving parts,
unplug cleaner before servicing.
how to remove
To prevent possible leaking, remove Clean Water
Solution Tank and Dirty Water Tank. Set tanks
aside. Press handle release pedal to lower handle.
Turn cleaner over so bottom is facing up.
5.2 Grasp inner portion of brush (A) and pull brush
assembly out slightly to reveal latches (B).
5.3 Press all four latches (B) and pull brush block
out. The brushes can be cleaned under running
water.
how to replace
5.4 Align posts (C) on both ends of brush assembly
with slots (D) in cleaner housing.
Make sure that square post (E) also aligns with
square hole (F). Turn brushes slightly until post fits
easily into hole.
Press brush assembly firmly to snap into place.

5. MaintenanCe

(Available on select models only)
®
carpet cleaner. Repeat as necessary until
!
17
5.2
b
A
b
b
5.4
e
C
Actual model may vary from images shown.
5.1
5.3
b
b
b
b
C
d
F
d