Related Manuals for Hoover vogue 5015PH
Summary of Contents for Hoover vogue 5015PH
- Page 1 vogue Cyclonic Bagless Vacuum Cleaner with Powerhead Compact Powerhead for a Powerful Clean vogue Washable HEPA Filtration Bagless, Cyclonic Technology High Efficiency Soft Start Motor...
-
Page 3: Specifications
5015PH Vogue Congratulations on the purchase of your new HOOVER vacuum cleaner. There are many useful features built into your cleaner and we recommend that you carefully read this instruction manual so that you may take best advantage of them. -
Page 4: Before You Begin
Before you Begin This cleaner must be operated in accordance with these instructions and used only for domestic household cleaning to remove DRY dirt and dust from household carpets, flooring, walls and fabrics. This cleaner is not fit to be used as an industrial cleaner hence will void the manufacturer’s warranty if used inappropriately. -
Page 5: Safety Precautions And Warnings
Safety Precautions & Warnings IMPORTANT! Always switch off the cleaner and remove the plug from the electricity power supply before cleaning your appliance, when not in use or attempting any maintenance task. The cleaner must only be connected to an AC power supply at the voltage shown on the rating label. - Page 6 Safety Precautions & Warnings 15. Ensure the appliance is disconnected from the 27. Always store the appliance indoors in a cool mains power supply before connecting the hose and dry place. to the unit. 28. Do not pick up water, dry household use only. 16.
-
Page 7: Assembling The Vacuum Cleaner
Assembling the Vacuum Cleaner Always remove the plug from the power socket before fitting or removing accessories! Connecting the Dust Container Subassembly Align the Assembled Align two marks position the mark Align the mark on the handle with the mark on the top cover, and fit the cover into the dust container. - Page 8 Assembling the Vacuum Cleaner 1. Fitting or Removing the Flexible Hose Fitting: Insert the flexible hose into the air intake duct of the vacuum. Press until it clicks into position. Removing: Remove the plug from the power socket and then release the flexible hose from the air intake duct by depressing the two buttons.
- Page 9 Ideal for daily cleaning on carpets and hard floors. Carpet Hard Floors Hand Turbo Brush Ideal for picking up pet hair on upholstery. Note: The hand turbo brush adaptor must be used to fit the telescopic tube to the accessory. Insert the smaller end of the adaptor into the end of the hand turbo brush.
-
Page 10: Crevice Tool
Accessories Combination Floor Head For use on hard floors and carpet. Powerhead For use on carpet for a deep clean. Crevice tool For radiators, crevices, corners, baseboards and between cushions. Upholstery tool For vacuuming furniture and upholstery. Dusting brush For furniture, blinds, bookshelves and lamp shades. Hand Turbo Tool For removing pet hair and dirt from upholstery and bedding. -
Page 11: Instructions For Use
Instructions for Use Before using the appliance, unwind a sufficient length of cable and insert the plug into the power socket. A yellow mark on the power cable shows the ideal cable length. Don’t expend the cable beyond the red mark. Press the ON/OFF button to turn the vacuum on. -
Page 12: Maintenance
Maintenance Ensure the vacuum cleaner is not connected to the power supply when performing any maintenance procedures. Use a damp cloth and mild detergent when cleaning the appliance. Vacuum Cleaner Storage When not in use, ensure the cleaner is not connected to the power supply, and pull the power cable gently out of the power socket. - Page 13 Blockage Inidicator Light If the blockage indicator light is on, switch off the cleaner, check there is no blockage in the filter, hose, inlet hole and empty the dust canister. Rear Motor HEPA and Filter Replacement The rear motor HEPA and filter is installed behind the air outlet grid, this filter is washable. When dust or dirt is visible on the surface of the filter, the filter should be replaced or washed with warm water to maintain efficient suction.
- Page 14 Maintenance (continued) Cleaning and Changing the Air Inlet Filter • The air inlet filter should be cleaned at least twice a year or when it becomes visibly dirty. • Always operate the cleaner with filters installed, otherwise, reduced suction or motor damage may result. •...
- Page 15 Hand Turbo Brush Warning: Ensure the cleaner is not connected to the mains power supply when performing any maintenance procedures. Unlock the neck on the hand turbo brush by twisting anti-clockwise. Push the release buttons on the side of the hand turbo brush down to unlock the external bristles.
- Page 16 Maintenance (continued) Hand Turbo Brush (continued) Replace the clear cover. Lock the neck on the hand turbo brush by twisting clockwise. Rotate the external bristles down and lock the side release buttons by pushing upwards.
- Page 17 Cleaning the Motorised Powerhead The rotating brush must be free of debris for effective cleaning and maximum suction. Disconnect the motorised powerhead and turn it over to inspect the bottom. If a buildup of debris is wound around the rotating brush, remove by carefully cutting with scissors.
- Page 18 Maintenance (continued) Changing the Motorised Powerhead Drive Belt (continued) First lift up the end of the rotating brush with no belt and remove it. Then lift the end cap where the belt loops around. End Cap Slide the old belt off the drive shaft and then the end cap.
-
Page 19: Troubleshooting
Ensure there are no blockages in the brush roller of the hand turbo tool. Please contact Hoover Customer Care: 1300 360 845 to find your local spare parts provider. Part Part Number... - Page 20 Cyclonic Bagless Vacuum Cleaner with Powerhead Conditions of Warranty Your Hoover cleaner, in the case of domestic use, has a two year Hoover Floorcare is unable to accept responsibility under this parts and labour warranty against product defects and failures when warranty for any repair work not carried out by an authorised Hoover Service Agent or from the use of non-genuine parts.