Inserting The Bobbin; Changing The Needle - Bernina Activa 210 User Manual

12 Setting up the sewing computer

Inserting the bobbin

Insert the bobbin
Insert the bobbin so that the
thread runs clockwise.

Changing the needle

Pull the thread counter clock-
wise into the slot.
Removing the needle
raise the needle
•
turn power switch to «0»
•
lower the presser foot
•
loosen the needle clamp screw
•
pull the needle down to remove
•
Inserting the needle
flat side of needle to the back
•
insert the needle as far as it will go
•
tighten the needle clamp screw
•
032622.50.04_0701_a210_EN
Pull the thread to the left
under the spring until ...
... it lies in the T-shaped slit at
the end of the spring.
The bobbin must turn clock-
wise when thread is pulled.
Please refer to the
safety instruction!