Bobbin case
To remove the bobbin case
raise the needle
•
turn power switch to «0»
•
open the bobbin cover
•
grasp the latch of the bobbin
•
case
remove case
•
To insert the bobbin case
hold the bobbin case latch
•
the finger on the case should
•
point upwards
insert so that it clicks into
•
place
032622.50.04_0701_a210_EN
Setting up the sewing computer
A
Bobbin thread cutter
insert the bobbin case
•
take the thread over cutter A
•
thread is cut
•
close the bobbin cover
•
Note:
The bobbin thread does not
have to be brought up as
the loose end is just the right
length to start sewing.
11
Please refer to the
safety instruction!