10
Setting up the sewing computer
Winding the bobbin
Winding the bobbin
turn power switch on
•
place empty bobbin on
•
spindle
Note:
When winding the bobbin
on the vertical spool holder
(p. 13), it may be necessary to
adjust the speed.
following the direction of the arrow take thread through the rear
•
guide and round the pre-tension stud
wind the thread two to three times around the empty bobbin
•
and cut off any excess thread on the thread cutter
press the engaging lever against the bobbin
•
press the foot control
•
the motor will stop automatically when the bobbin is full
•
remove the bobbin
•
032622.50.04_0701_a210_EN
Thread cutter
cut the thread on the thread
•
cutter