Cleaning
If the sewing computer is stored in a cold room, it should be
brought to a warm room about one hour before use.
Clean the sewing computer after every use
turn power switch to «0» (off) and pull out
•
plug from electric outlet
remove presser foot and needle
•
open the free-arm cover
•
press the stitch plate down at the back right
•
corner, lift and remove
clean the area with the lint brush
•
replace the stitch plate
•
Cleaning the hook
turn power switch to «0» (off) and pull out
•
plug from electric outlet
remove the bobbin case
•
push the release lever to the left
•
push the locking lever to the left and fold
•
down the hook race cover
remove the hook
•
clean the hook race with a cloth or brush,
•
never use a sharp instrument
replace the hook, turning the handwheel if
•
necessary so that the hook driver is on the left
close the hook race cover and secure with the
•
locking lever, the locking pin must engage
check by turning the handwheel
•
insert the bobbin case
•
032622.50.04_0701_a210_EN
Maintenance
Lubricating
squeeze 2–3 drops of oil into the hook race
•
run the machine for a short time without
•
thread to prevent oil soiling your work
Cleaning the LCD display and the sewing
computer
wipe with a damp cloth
•
Important!
Never use alcohol, petrol, white spirit or any
type of solvent to clean the sewing computer!
Please refer to the safety instruction!
31
CAUTION
Disconnect plug
from the socket
before cleaning
and servicing