Sewing preparations
Sewing preparations
ng
prepar
Winding a Bobbin
Inserting a Bobbin
12
⦁
turn power switch on (to «I»)
⦁
place empty bobbin on spindle
⦁
place thread on spool pin
⦁
attach appropriate spool disc; diameter of thread spool determines disc size
⦁
following the direction of the arrow take thread through the rear guide and
round the pre-tension stud
⦁
wind the thread two to three times around the empty bobbin and cut off any
excess thread on the thread cutter
⦁
push engaging lever against bobbin, the winder works automatically
⦁
the motor will stop automatically when the bobbin is full
Thread cutter
⦁
pull thread over thread cutter when removing the bobbin
Bobbin winding while sewing
⦁
place thread spool on vertical spool pin then, following the direction of the
arrow, take thread through the thread guide and around the pre-tension
stud
⦁
then proceed as mentioned above
Insert the bobbin so that the thread runs clockwise.
Laying the thread into the slot
Pull the thread counter clockwise into the slot.
Pulling the thread under the spring
Pull the thread to the left under the spring until it lies in the T-shaped slit at the
end of the spring. The bobbin must turn clockwise.