Table of Contents
Advertisement
If you have other devices to install or remove, do so now; otherwise, go to
"Completing the installation."
Completing the installation
To complete the installation, you must reinstall the two-piece bezel, reinstall the side
cover, connect all the cables and, for some devices, run the Setup utility. Follow the
instructions in this section.
Reinstalling the two-piece bezel
To reinstall the two-piece bezel, complete the following steps:
1. Install the upper bezel on the front of the server chassis:
62
System x3200 M3 Types 7327 and 7328: Installation and User's Guide
a. Insert the two right-side tabs on the upper bezel into the matching holes on
the right side of the chassis.
b. Rotate the upper bezel to the left side of the chassis and press the bezel
clips into the matching indentations on the left side of the chassis until the
bezel clips snap into place.
Advertisement
Table of Contents
