Table of Contents
Advertisement
Attention:
to change, override, or remove it. You must replace the system board.
Resetting passwords
If you forget the power-on password or administrator password, you can move the
clear-CMOS jumper block on the system board to pins 2 and 3, to clear CMOS
memory and bypass the power-on or administrator password check. The jumper
location is shown in the following illustration.
Using the Boot Manager program
The Boot Manager program is a built-in, menu-driven configuration utility program
that you can use to temporarily redefine the first startup device without changing
settings in the Setup utility.
To use the Boot Manager program, complete the following steps:
1. Turn off the server.
2. Restart the server.
3. When the prompt <F12> Select Boot Device is displayed, press F12. If a
4. Use the Up Arrow and Down Arrow keys to select an item from the Boot
The next time the server starts, it returns to the startup sequence that is set in the
Setup utility.
If you set an administrator password and then forget it, there is no way
Boot block
jumper (JP6)
bootable USB mass storage device is installed, a submenu item (USB
Key/Disk) is displayed.
Selection Menu and press Enter.
Clear CMOS
jumper (JP1)
Chapter 3. Configuring the server
73
Advertisement
Table of Contents
