Table of Contents
Advertisement
Chapter 3. Configuring the server
The following configuration programs and utilities come with the server:
v Setup utility
v Boot Manager program
v IBM ServerGuide Setup and Installation CD
v Integrated management module
v VMware ESXi embedded hypervisor
v Remote presence capability and blue-screen capture
v Ethernet controller configuration
v LSI Configuration Utility program
© Copyright IBM Corp. 2010
The UEFI (formerly BIOS) Setup Utility program is part of the basic input/output
system firmware. Use it to change interrupt request (IRQ) settings, change the
startup-device sequence, set the date and time, and set passwords. For
information about using this program, see "Using the Setup utility" on page 68.
The Boot Manager program is part of the server firmware. Use it to override the
startup sequence that is set in the Setup utility and temporarily assign a device to
be first in the startup sequence. For more information about using this program,
see "Using the Boot Manager program" on page 73.
The ServerGuide program provides software-setup tools and installation tools
that are designed for the server. Use this CD during the installation of the server
to configure basic hardware features, such as an integrated SAS/SATA controller
with RAID capabilities, and to simplify the installation of your operating system.
For information about using this CD, see "Using the ServerGuide Setup and
Installation CD" on page 74.
Use the integrated management module (IMM) for configuration, to update the
firmware and sensor data record/field replaceable unit (SDR/FRU) data, and to
remotely manage a network. For information about using the IMM, see "Using the
integrated management module" on page 76.
The VMware ESXi embedded hypervisor is available on the server models that
come with an installed the USB embedded hypervisor flash device. The USB
flash device is installed in the USB connector on the system board. Hypervisor is
virtualization software that enables multiple operating systems to run on a host
system at the same time. For more information about using the embedded
hypervisor, see "Using the embedded hypervisor" on page 77.
The remote presence and blue-screen capture feature are integrated into the
integrated management module (IMM). The virtual media key is required to
enable the remote presence functions. When the optional virtual media key is
installed in the server, it activates the remote presence functions. Without the
virtual media key, you will not be able to access the network remotely to mount
or unmount drives or images on the client system. However, you will still be able
to access the Web interface without the virtual media key. You can order the
optional IBM Virtual Media Key, if one did not come with your server. For more
information about how to enable the remote presence function, see "Enabling the
remote presence feature" on page 79.
For information about configuring the Ethernet controller, see "Configuring the
Gigabit Ethernet controller" on page 80.
Use the LSI Configuration Utility program to configure the integrated SAS/SATA
controller with RAID capabilities and the devices that are attached to it. For
information about using this program, see "Using LSI Configuration Utility
program" on page 81
67
Advertisement
Table of Contents
