How To Restore Recording After Power Failure; External Timer Recording; Tape End Buzzer - JVC SR-L910UA - 24 Hour Time Lapse Vcr Instructions Manual

7 RECORDING

7-9 How to Restore Recording After Power Failure

If a power failure occurs during recording, recording will
restart in the same mode as soon as power is restored.
To use this function, set the function menu switch <AUTO
REC> to ON.
* If this function menu switch is set to ON and power is
turned off and on again in the Stop mode, the VCR
enters the Record mode automatically. Be careful.

7-10 External Timer Recording

External timer recording can be performed by connecting the SR-L910UA to an external timer.
1
Check that a cassette is loaded in the VCR.
* If the cassette's safety tab has been removed,
recording will not take place.
* This function does not work when the Timer Record
mode is engaged.

7-11 Tape End Buzzer

When set to ON, a buzzer sounds when the tape ends
during recording. To set the buzzer sound on, set the
function menu switch <TAPE END BUZZER> to ON.
5 Select the tape end buzzer output timing with the <REC
REMAIN> function switch on the VTR mode 2 setting
screen.
OFF : Tape end
180S : Remaining time is about 3 minutes during 2H
mode
360S : Remaining time is about 6 minutes during 2H
mode
When the tape reaches the specified position, the
following signals are output in addition to the tape end
buzzer sound.
• Tape end signal from the rear panel's [TAPE END
OUT] terminal
• Series recording signal from the rear panel's [SERIES
OUT] terminal during series recording
• "End" indication in the counter display
5 To stop the buzzer sound, you can set the <TAPE END
BUZZER> function menu switch to OFF, turn off the
power, or press another operation button.
5 During repeat recording and AUTO REW, the buzzer
sounds for about 2 seconds.
VTR MODE 1
(SHARPNESS)
(AUTO REC)
AUTO REC
(REC CHECK)
(TAPE END MODE)
(INDEX SEARCH)
(CAMERA SW)
(TAPE END BUZZER)
(WARNING BUZZER)
PRESS (SHIFT, SET)
PRESS (MENU)
VTR mode 1 setting screen
2
Set the function menu switch <AUTO REC> to ON.
Power is supplied from the external timer at the
specified time and recording starts.
VTR MODE 1
(SHARPNESS)
(AUTO REC)
(REC CHECK)
(TAPE END MODE)
(INDEX SEARCH)
(CAMERA SW)
TAPE END
(TAPE END BUZZER)
(WARNING BUZZER)
BUZZER
PRESS (SHIFT, SET)
PRESS (MENU)
VTR mode 1 setting screen
NORMAL
ON
Set to
MANUAL
ON
REPEAT
OFF
OFF
OFF
OFF
TO END
NORMAL
ON
MANUAL
REPEAT
OFF
OFF
Set to
ON
OFF
ON
TO END
39