Rear Panel - JVC SR-L910UA - 24 Hour Time Lapse Vcr Instructions Manual

2 CONTROLS AND CONNECTORS
2-1 FRONT PANEL

2-3 Rear Panel

1
CAM SW ALARM
OUT IN
COM ALARM
RESET
1
Power cable
Connect the power plug to an AC 120 V, 50/60 Hz
outlet.
2
[MIC IN] mic input connector
Connect a microphone with 3.6-mm dia. plug. When
signals are input from both the microphone connector
and the audio input connector, audio signals are mixed
and recorded.
3
[VIDEO IN] video input connector (BNC)
Receives composite video signals from a connected
camera or other video source.
4
[AUDIO IN] audio input connector (RCA)
Receives audio signals from a connected audio source.
5
[AUDIO OUT] audio output connector (RCA)
Outputs audio signals.
6
[VIDEO OUT] video output connector (BNC)
Outputs composite video signals. Input camera signals
(composite video signals) can still be output through this
connector even when no power is supplied to the unit
(Power-Off Video Throughput function).
7
[REMOTE] remote connector
Connect the optional RM-G30U remote control.
ALARM SERIES/CLOCK
COM
REC OUT
WARNING
TAPE /REC
END OUT OUT IN OUT
8
2 3
MIC
VIDEO
IN
IN
CAM SW ALARM ALARM COM SERIES/CLOCK
OUT IN REC OUT REMOTE
WARNING
COM ALARM TAPE /REC
RESET END OUT OUT IN OUT
OUT
7
6
Connecting the wires to the terminals
button
8
[SERIES/CLOCK OUT] series recording signal/clock
reset signal output terminal
Outputs the series recording signals or clock reset
signals.
Select the output signal with the <TERMINAL SEL 1>
menu switch.
• Series recording signal output
When the <TERMINAL SEL 1> menu switch is set to
"SERIES", the series recording signal is output.
• Connect to the other VCR series recording signal input
terminal. When the tape being recorded in this unit
ends, a signal is output from this terminal to the
connected VCR.
• Select the signal output timing with the <REC
REMAIN> menu switch (tape end, or about 3 minutes
or 6 minutes before the tape ends during 2H mode).
• Clock reset signal output
When the <TERMINAL SEL 1> menu switch is set to
"C.ADJ", the clock reset signal is output when the
internal clock is at AM0:00 and PM0:00. When
connected to the [CLOCK IN] terminal of another SR-
L910UA, this unit's time can be synchronized with the
time on the other VCR if the time difference is within
±30 seconds.
4
AUDIO
IN
OUT
5
8
1. Hold the button down
and insert the wire
over the top of the
terminal.
2. Release the button to
lock the wire in the
terminal.
11