Samsung SCP-3120 User Manual page 90

troubleshooting
Problem
The camera's position differs
from the position defi ned in a
preset.
Sequence confi guration of the
camera does not work.
The upper side of the picture is
dark when the camera is on the
horizontal reference point.
Camera suddenly turns on or
moves to a preset position by
itself.
• The Power cord's coating has
been damaged.
• The power cord is hot to touch
when the product is in
operation.
• The power cord gets hot after
being folded or pulled on.
90_ troubleshooting
Cause and Solution
This phenomenon may happen, since the motors have
a margin error of ±0.1˚.
Check if Preset or another operation mode has been
set.
Check the Auto Refresh settings.
You are seeing the camera's internal cover. The
camera is functioning normally.
Check the Auto Run settings.
Auto Run puts a camera through a predefi ned action
sequence if the user does not use the Controller to
operate the camera for a certain period of time.
Continuing to use the product when its power cord is
damaged constitutes an electrical and fi re hazard. The
power plug must be removed from the outlet
immediately, and a qualifi ed service personnel or your
system provider should be contacted for assistance.
PAGE
-
58~62
85
-
67
-