JVC KY-F560U - 3-ccd Color Camera Instruction Manual page 19

Connecting to Remote Control Unit RM-P210 (continued)
GENLOCK IN VIDEO OUT
DC IN
POWER
SEE INST
INCOM MIC
ON CARBON
OFF DYNAMIC
INTERCOM
INCOM LEVEL CALL
MIN MAX
[CARBON/DYNAMIC]
switch
[INCOM MIC ON/OFF] switch
Operation
● Turn the [POWER] switch of the camera remote control unit to [ON]. After the [POWER]
switch is turned on, camera remote control unit could be operated after about 30 seconds.
Note
After the power is turned on, the camera remote control unit takes about 30 seconds to
be ready to communicate with this unit.
GENLOCK IN VIDEO OUT
DC IN POWER
SEE INST
INCOM MIC
ON CARBON
OFF DYNAMIC
INTERCOM
INCOM LEVEL
MIN MAX
[INCOM LEVEL]
volume
Note
● If both this unit (including the camera) and the remote control unit have the same func-
tional switches, the remote control unit switches will be accorded higher priority.
● If local Remote Control Unit (RM-LP55 or RM-LP57) is used simultaneously, the local
remote control unit will be accorded higher priority.
● When synchronization signal is added to both the camera and the camera remote con-
trol unit, pictures will be distorted. (☞ page 9 'Regarding Gain-lock Signal and adjust-
ment of System Phase')
● If external synchronization signal is present when the power is turned on, pictures may
appear jerky for a few seconds. This is not a malfunction.
● When using the remote control unit, refer to its instruction manual for details.
Rear view of
● Set the [CARBON/DYNAMIC] switch according to
this unit
VF
● Set the [INCOM MIC ON / OFF] switch depending
● When this unit's [CALL] button is pressed and held
VF
[CALL]
CALL
Indicator
[CALL] button
● The headset reception volume could be adjusted
Switch setting
the type of intercom headset microphone to be
used. (If JVC Headset KA-310U is connected,
choose the [CARBON] setting.))
on whether headset microphone will be used. If the
switch is set to [ON], then the headset microphone
could be used.
down, call signals will be sent to the remote control
unit operator and the [TALLY] button indicator of
the remote control unit will blink.
During this duration, the [CALL] indicator of this unit
will light up. The Viewfinder's [TALLY] lamp will also
blink when call signals are received from the re-
mote control unit.
by [INCOM LEVEL] volume.
19