Connecting Rm-P210 Connecting To Remote Control Unit Rm-P210 - JVC KY-F560U - 3-ccd Color Camera Instruction Manual

Connecting RM-P210
Connecting to Remote Control Unit RM-P210
Headset
KA-310U
TALLY CALL FULL AUTO F1
SHUTTER
BARS F2
GAIN
INTERCOM
LEVEL
Remote control unit RM-P210
Monitor
Connection
Switch off RM-P210 power supply before attempting the connection.
● Connect this unit's RM multi-pin connector and RM-P210 using the 26 Pin camera cable.
Length of the camera cable should not be longer than 100 m.
● If intercom headset is to be used, plug the Headset KA-310U into the [INTERCOM] termi-
nal.
● Prompter video (RM-P210 [AUX VIDEO INPUT] terminal's input signal) from RM-P210
could be verified by connecting this unit's [PROMPTER OUTPUT] terminal located in front
of it to a monitor using BNC cable.
Note
Power for this unit and the camera is supplied by RM-P210 via the 26 Pin camera cable.
Setting
Menu screen setting
● Composite video signal is always output at the RM multi-pin connector.In addition, another
type of video signal which could be either RGB component, Y/Cb/Cr component or YC
separate signal could be outputted. The output signal could be selected using the "OUT-
PUT" item under the "SYSTEM" menu screen.
● If the output signal is RGB component, option to superimpose SYNC signal onto the G
signal could be selected through the "SYNC ON G" item under the "SYSTEM" menu screen.
18
REMOTE CONTROL UNIT RM-P210
MENU/SHUTTER GAIN WHITE MASTER BLACK IRIS POWER
F3 PAINT AUTO
STEP W.BAL
HIGH B
I
SHUTTER VARIABLE MID A
AUTO
PUSH-ON PUSH-ON
F4 MENU R B MANU
LOW PRESET
O
DOWN UP DOWN UP CLOSE OPEN
PROMPTER
OUTPUT RM
[PROMPTER OUTPUT] terminal
26 Pin
camera
cable
RM Multi-pin
INTERCOM
connector
[INTERCOM] terminal
BREAKER
AW BARS
MENU SET
Headset
REMOTE LENS
VIDEO OUT
GENLOCK IN
DC IN
POWER
KA-310U
SEE INST
INCOM MIC VF
ON CARBON
OFF DYNAMIC
INCOM LEVEL CALL
MIN MAX
26 Pin camera cable
VC-P110 (5 m)
VC-P112 (20 m)
VC-P113 (50 m)
VC-P114 (100 m)