Throtlle Cable; Carburetor - GAS GAS EC 125 - 2003 Service Manual

- Inspect the element for damage such as tears, hardening, or
shrinkage. If damaged, replace it or it will allow dirt into the carburetor.
- Apply grease to all connections and srew hole in the air cleaner
housing and intake tract.
- Install the seat.

THROTLLE CABLE

- Inspect the throttle grip for smooth operation in all steering positions.In
accordance with the Periodic Maintenance Chart, check and adjust
the throttle cable.
. Check that the throttle grip has 2-3 mm of play and turns smoothly.
. If the play is incorrect, loosen the locknut on the upper end of the
throttle cable, and turn the adjuster to obtain the correct amount of
play. Tighten the locknut.
(C) (B) (A)
- Install the element in
the machine (A), and
make sure the sealing
surface of the element
is seated properly.
(A). Adjuster.
(B). Locknut.
(C). Throttle grip.
EC 2003 -
- If the free play cannot beset by adjusting the upper cable adjuster,
pull the rubber boot off of the carburetor top. Make the necessary
free play adjustment at the lower cable adjuster, tighten the locknut,
and reinstall the rubber boot.

CARBURETOR

Idling Adjustment
Iding adjustment is carried out using the air screw (A) and idle
ajusting screw (B).
- First turn in the air screw until it seats lightly, and back it out 1 1/2
turns.
- After thoroughly warming up the engine, turn the idle adjusting
screw to obtain the desired idle speed. If no idle is preferred, turn
out the screw until the engine stops.
- Open and close the throttle a few times to make sure the idle speed
does not change. Readjust if necessary.
- With the engine idling, turn the handlebar to each side. If handlebar
movement changes the idle speed, the throttle cable may be
improperly adjusted or incorrectly routed, or it may be damaged. Be
sure to correct any of these conditions before riding.
84
-
(B)
(A)