Table of Contents
Advertisement
Completing the venue and adding the arrays
3)
Now take the first (floor only) ViewPoint set-up and add the balcony data from the
second one to make a complete venue
a) Increase the number of W8LCs to 10 (for the complete system)
b) Set the coverage start as set for the floor only and the coverage stop as set for the
balcony only
c) Set the array height so that the lowest (Z) point is the same as it was for the floor
only set- up in step 1)
d) Switch ViewPoint to manual operation and to the array page
i.
Set the lower 5 cabinet angles (7-10) to those used for the previous lower
section in step 1)
ii.
Set angle 6 (the angle between the upper and lower sections) to 7.5°
iii.
Set the grid tilt and upper 5 cabinet angles (1-5) to those used for the
previous upper section in step 2)
Complete system
All material © 2007. Martin Audio Ltd. Subject to change without notice.
Hide quick links:
Advertisement
Table of Contents
