Grounding Instructions; Operating Instructions; Cleaning And Maintenance; Operating Heater - Desa CGESBM Safety And Operation Manual

GROUNDING
INSTRUCTIONS
This stove is for use on 120 volts. The cord has a
plug as shown in Figure 2. An adapter is available
for connecting three-blade grounding-type plugs
to two-slot receptacles. The green grounding lug
extending from the adapter must be connected to
a permanent ground such as a properly grounded
outlet box. The adapter should not be used if a
three-slot grounded receptacle is available.
Figure 2 - Grounding Methods
OPERATING
INSTRUCTIONS
Once the unit has been properly connected to a
ground electrical outlet, it is ready to operate.
Note: Ensure the circuit breakers for power
supply are turned on.
CONTROL PANEL OPERATION
Controls are located on the back of the unit
(see Figure 3).
1. Main ON/OFF power switch: This switch is
located at the furthest right corner on the
control panel when looking at the back of
the unit. Turn the switch to ON and unit
will be ready to operate. The "|" indicates
ON and "O" indicates OFF.
2. Heater Switch and Control Dial: The
heater switch has a sun directly below it. To
turn the heater on, flip the Heater Switch
to ON position (the "|" indicates ON and
"O" indicates OFF). The Control Knob
has a thermometer below it. Turn the dial
clockwise past the number 8. You should
hear a small clicking sound indicating the
heater has started and heat will emit the
from the vents at the top of the unit. To
turn off heater, turn the temperature dial
counter clockwise past number 1 and flip
the Heater Switch to OFF position.
To increase the desired temperature, turn
the temperature dial clockwise towards
Number 8.
4
To decrease the desired temperature, turn the
temperature dial counter clockwise towards
number 1. The heater has a built-in thermo-
stat so it will shut off automatically once the
set temperature is reached. It will also turn on
automatically if the room temperature drops
below the set temperature on the dial.
Note: When the heater is turned on for the
first time, it may release a slight, harmless
odor. This odor is a normal occurrence caused
by the initial heating of the internal heating
elements and should not occur again.
4. Flame Control Dial: This dial controls the
intensity of the flame.
Flame
Control Dial
Heat Control
Dial
Figure 3 - Electric Stove Control Panel
www.desatech.com
Main Power Switch
Heater
Light Adjustment
Switch
Dial
117191-01A