Table of Contents
Advertisement
GROUNDING
INSTRUCTIONS
This stove is for use on 120 volts. The cord has a
plug as shown in Figure 2. An adapter is available
for connecting three-blade grounding-type plugs
to two-slot receptacles. The green grounding lug
extending from the adapter must be connected to
a permanent ground such as a properly grounded
outlet box. The adapter should not be used if a
three-slot grounded receptacle is available.
Figure 2 - Grounding Methods
OPERATING
INSTRUCTIONS
Once the unit has been properly connected to a
ground electrical outlet, it is ready to operate.
Note: Ensure the circuit breakers for power
supply are turned on.
CONTROL PANEL OPERATION
Controls are located on the back of the unit near
the top (see Figure 3).
1. Main ON/OFF power switch: This switch is
located at the furthest right corner on the
control panel when looking at the back of
the unit. Turn the switch to ON and unit
will be ready to operate. The "|" indicates
ON and "O" indicates OFF.
2. Flame ON/OFF Switch: This switch is
located in the middle between the Main
ON/OFF switch and the Heater ON/OFF
switch on the control panel when looking at
the back of the unit. Turn the switch to ON
and the flame effect will turn on. The "|"
indicates ON and the "O" indicates OFF.
3. Heater ON/OFF Switch: This switch is
located to the left of the Flame ON/OFF
switch on the control panel. It has a symbol
of the sun directly below it.
4. Thermostat Control Dial: This dial is located
at the furthest left corner on the control panel.
It has a symbol of a thermostat directly below
it. Turn the dial clockwise past the number 8.
4
Figure 3 - Electric Stove Control Panel
www.desatech.com
Flame Switch
Built-In
Thermostat
Main Power
Switch
Heater Switch
117889-01B
Advertisement
Table of Contents
