Unpacking; Product Identification; Chain Saw Names And Terms - Remington 107624-01 Owner's Manual

UNPACKING

1. Remove all items from carton.

PRODUCT IDENTIFICATION

Switch Lockout
Rear Handle
Power Cord
Cord Hitch
Figure 2 - Chain Saw Model 107624-01, -02
Switch Lockout
Rear Handle
Power Cord
Cord Hitch
Figure 3 - Chain Saw Model 107625-01, -02, 111174-01
CHAIN SAW NAMES AND
TERMS
Process of cutting a felled tree or log into
Bucking
lengths.
Block or wedge used to secure wood from
Chock
moving.
Process of cutting down a tree.
Felling
Final cut when felling a tree. Make this
Felling Cut
cut on opposite side of tree from notching cut.
Located at front of saw body.
Front Handle
Shield between front handle and
Front Hand Guard
guide bar. Protects left hand while using saw.
Metal bar that extends from saw body.
Guide Bar
The guide bar supports and guides chain.
Tip or end of guide bar.
Guide Bar Nose
Quick backward and upward motion of
Kickback
guide bar. Kickback may occur when tip of guide
bar touches an object while chain is moving. The
guide bar will kick up and back towards operator.
Process of cutting limb(s) from a felled tree.
Limbing
Chain that reduces chance of
Low-Kickback Chain
kickback as required by ANSI B175.1.
Normal Cutting Position
www.desatech.com
107705-01
Oil Level Sight
Oil Cap
Adjusting Screw
Trigger
Oil Level Sight
Oil Cap
Thumbscrew
Trigger
Stance used while mak-
8
8
2. Check all items for any shipping damage. If you
find any damage or if any parts are missing, call
Technical Services at 1-800-858-8501 for prompt
service.
Front Handle with Hand Guard
Saw Chain
Front Handle with Hand Guard
Saw Chain
Guide Bar
ing bucking and felling cuts.
Notch cut in tree that directs fall of tree.
Notching Cut
System for oiling guide bar and chain.
Oiler Control
Chain saw without chain and guide
Power Head
bar. Also known as saw body.
Pushback (Kickback, Pinch)
saw. Pushback may occur if chain along top of guide
bar is pinched, caught, or contacts a foreign object.
Handle located at rear of saw body.
Rear Handle
Reduced Kickback Guide Bar
duces chance of kickback.
Chain that complies with ANSI
Replacement Chain
B175.1 when used with a specific saw. It may not
meet ANSI requirements when used with other saws.
Loop of chain having cutting
Saw Chain (Chain)
teeth for cutting wood. The motor drives chain. The
guide bar supports chain.
Spiked Bumper (Spike)
saw body beside guide bar. Keep spiked bumper in
contact with wood when felling or bucking. It helps
maintain position of saw while cutting.
Toothed wheel that drives chain.
Sprocket
Device that completes or interrupts electri-
Switch
cal circuit to motor of saw.
12/16/03, 4:07 PM
Guide Bar Nose
Guide Bar
Guide Bar Nose
Rapid pushback of chain
Guide bar that re-
Pointed teeth at front of
107705