Connecting A Component Connections (Better Than S-Video Picture Quality); To Change The Speaker Cable; Connecting The Antenna Terminals - Denon S-101 Operating Instructions Manual

Connecting Other Sources
Connecting a component connections
(Better than S-Video picture quality)
PROGRESSIVE/INTERLACED
• Set the "TV TYPE" in "VIDEO SETUP" in "SETUP" in "HELP" to comply with your TV's video
format. When the TV is NTSC formatted set to NTSC.
• When the PROGRESSIVE/INTERLACED switch on the ADV-S101's rear panel is set to
"PROGRESSIVE", no video signals are output from the VIDEO OUT or S-VIDEO OUT terminals.
Set the PROGRESSIVE/INTERLACED switch on the ADV-S101's rear panel to "INTERLACED", if you
want to use the VIDEO OUT or S-VIDEO OUT signals. (
2 To switch from interlace to progressive
• Turn off the power before changing the switch.
• Choose settings according to the TV to be connected.
• Set the PROGRESSIVE/INTERLACED switch on the ADV-S101's rear panel to
select the type of the TV.
PROGRESSIVE:
Select this when using the ADV-S101 connected to a progressive type TV.
INTERLACED:
Select this when using the ADV-S101 connected to an interlace type TV.
• For the component output only, it is possible to switch between interlace image output and
progressive image output. It is not possible to specify progressive image output for the Video
output connectors or S-Video output connector.
Refer to the procedure below if you want to switch to a different speaker cable. This example
describes how to mount the "+" side cable to the connector. Mount the "–" side cable in the same
Monitor TV
way.
q Insert the included hexagonal wrench into the hole
D F
COMPONENT VIDEO IN
Y
w Turn the hexagonal wrench in the direction of
P /C
B B
P /C
R R
e Pull out the old cable. Be careful not to leave any
r Peel off the cable's sheath and insert the new
t Turn the hexagonal wrench in the direction of
If the polarities are inverted, the phase may be off and the bass sound may be missing, resulting
in an unnatural sound.
page 11, 15).
• An F-type FM antenna cable plug can be connected directly.
• If the FM antenna cable's plug is not of the F-type, connect using the F-type antenna adapter
16
ENGLISH

To change the speaker cable

at the side of the connector's "+" side. (Arrow A)
arrow B to loosen the cable.
broken wire parts inside the connector. (Arrow C)
cable with the copper colored core wire twisted
tightly together into the connector. (Arrow D)
Arrow E and tighten securely so that the cable cannot be pulled out. Be sure to connect both
sides of the cable to the connectors with the proper polarities.

Connecting the antenna terminals

(Option).
FM antenna
Direction of
broadcasting station
FM antenna
adapter
75 Ω/ohms
(Option)
COAXIAL cable
NOTE:
• Do not connect two FM antennas
simultaneously.
• Even if an external AM antenna is used, do
not disconnect the AM loop antenna.
• Make sure AM loop antenna lead terminals
do not touch metal parts of the panel.
ENGLISH
Connecting Other Sources
A
C
E
D B
AM loop antenna
(Supplied)
White
Black
AM outdoor
antenna
Ground