Remote Eontrol Unit Openrtions; Setting The Preset Memory Function; Operating A Component Stored In The Preset Memory; Setting The Punch Through Function - Denon S-102 Owner's Manual

ENGLISH
Remote Control Unit Operations
I
Signal trar.lsmission
indicator
r-- . ,
[TV INPun----4-B
i;:
'1~'
I
[AUDIO/RDS]
l.-E)
G-+-[ZOOM/Rn
f~··~-~0.-[NUMBER]
tg.:8:~!
I
t(;J!G
t
~[REPEAn
----+-[CAll]
Setting the preset memory function'
DEN ON and other makes of components can be operated
by setting the preset memory.
This remote control unit can be used to operate components
of other manufacturers without using the. learning function,
by registering the manufacturer of the component
as:
shown in the Jist ofpreset codes(r:rEnd ohhis manual).
1
Set
[SOURCE CONTROL]
to the component to be
registered.
2 Press
[AUDIO/RDS]
and
[ZOOM/Rn
at the same
time.
The indicator starts flashing.
3
Referring to the included list of preset codes
(n:§'
End
of this manual), press
[NUMBER] (0 - 9)
to input the
preset code (a 3-digit number) for the manufacturer
of the component whose signals you want to store in
the memory.
Operating a comporientstored in the
preset memory
1
Set
[SOURCE CONTROL]
to the component you want
to operate.
2
Operate the component.
*
For details, refer to the component's operating instructions.
' *
Some models cannot be operated with this remote control unit
Setting the punch through function
"Punch Through" is a function allowing you to operate
[SOURCE CONTROL] and [TV INPUn on "lV; "SAT/CABLE"
or "VCR" components when in the "OVO / CO / FM/AM /
iPod" mode. By default. nothing is set.
1
Set
[SOURCE CONTROL]
to the component to be
registered (DVD / CD / FMlAM / iPod).
2
Press
[CALL]
and
[REPEAn
at the same time.
The indicator starts flashing.
Number
TV 1
SAT/CABLE
2
VCR 3
No setting 0
3
Input the number of the component you want to set.
4
To store the codes of another component in the
memory, repeat steps 2 to 3.
• The signals for the pressed buttons are emitted while setting the
preset memory. To avoid accidental operation, cover the remote
control unit's transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes listed in
the list of preset codes.
• Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number and
verify correct operation.
• Operation is not possible for some models.
About the button names in these explanations
< > : Buttons on the main unit
[ I :
Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
[SO
~~
URCE
---+--o.-,,,!?.
CONTROL]
32