Troubleshooting - Kodak 5600 - BC5601 Carousel Projector Operating Manual

Troubleshooting

PROBLEM
Projector does not operate
No illumination on screen with slide in
projector gate
Slide not in proper focus on screen
focus.
Uneven edge-to-edge focus
Autofocus has difficulty slide to slide
26
Consult this guide before calling for service.
CAUSE
No power to projector
Power switch on Off or Fan
Lamp burned out
Lamp not seated in socket
Slide itself not sharp
First slide in tray not properly focused Focus center of first slide
Slide in different type of mount from
others
Projection lens installed improperly
Slide itself is not sharp
Curved field lens used with glass,
plastic, or non-embosssed mounts
Curved field lens used for rear
projection
Lamp performance
Mixed open and glass slide mounts
CORRECTION
Plug power cord into suitable
electrical outlet. Set power
switch to Lamp.
Set switch to Lamp.
Install new lamp or lamp module
Check lamp.
Examine slide for proper focus.
manually.
Focus manually.
Read and follow the instructions
for installing the lens.
Examine slide.
Try a flat field lens.
(See "Choosing a Curved- or
Flat-Field Lens" on page 14.)
Use a flat field lens.
UInstall new lamp and try again.
Do not mix open and glass mounts
KODAK CAROUSEL® Slide Projector