System Call - Denon AVR-4802R Operating Instructions Manual

Denon av surround receiver operating instructions avr-4802r
Hide thumbs Also See for AVR-4802R:
Table of Contents

Advertisement

System call

The accessorious remote control unit is equipped with "system call" function allowing a series of remote control signals to be transmitted by
pressing a single button.
This function can be used for example to turn on the receiver's power, select the input source, turn on the monitor TV's power, turn on the source
component's power and set the source to the play mode, all at a signal button.
(1) System call buttons
Up to 10 signals each can be stored at the "CALL1" and "CALL2"
buttons.
(2) Storing system call signals
1
Press the power ON/SOURCE button and the OFF button at
the same time.
"PRE" appears on the remote control unit's display.
2
Use the • and ª cursor buttons to display "CALL" on the
remote control unit, then press the ENTER button.
Display "SEL" on the remote control unit's display.
3
Use the • and ª cursor buttons to display the name of the
device you want to register at the system call button, then
press the ENTER button.
Display "KEY" on the remote control unit's display.
The display switches as shown below each time the • and
ª cursor buttons are pressed.
AMP
MULTI
CD
TV
CABLE
It is also possible to select the mode directly using the
mode buttons.
4
Press the button you want to register. "SET" is displayed and
the button is registered.
Once the button is registered, the "KEY" indicator
reappears and the next button can be registered.
DVD
CDR
MD
TAPE
DBS
VCR2
VCR1
VDP
(1)
1
DVD
5
2, 3
7
5
The mode can be switched by pressing a mode button while
the "KEY" indicator is lit.
Press the ENTER button to turn the "KEY" indicator back on,
setting the registration standby mode.
6
Repeat steps 4 and 5 to register the desired buttons.
When settings are stored at all 10 keys, "FULL" is displayed
and no more settings can be stored.
7
Press the "CALL1" or "CALL2" button
while the "KEY" or "FULL" indicator is lit
to register the signals at the system call
button.
"OK" is displayed and the set returns to
the normal operating mode.
1
2, 3, 5
39

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents