McAfee VIRUSSCAN 4.5 Administrator's Manual page 62

Installing VirusScan Software
Component Name
McUpdate
ShellExtentions
ScreenScan
SendVirus
To use these component names in a command line, specify the destination and
the component name, exactly as it appears in the table.
For example, to add the VirusScan application to the local system, type this
line at the command prompt:
setup.exe ADDLOCAL=Scan32/q/i
Use a comma to separate values in order to install more than one component.
To add Scan32 and SystemScan together, for example, type this line at the
command prompt:
setup.exe ADDLOCAL=SystemScan,Scan32/q/i
To do a complete installation, type this line at the command prompt:
setup.exe ADDLOCAL=ALL/q/i
To remove all VirusScan components, type this line at the command prompt:
setup.exe REMOVE=ALL/q/i
To install all components except for one—the SendVirus component, in this
example—type this line at the command prompt:
setup.exe ADDLOCAL=ALL REMOVE=SendVirus/q/i
You can also choose different components for an installation that you do not
run silently. If, for example, you leave off the /q option in any of the command
line examples shown above the Custom Setup wizard panel (see
page
installation. If you use these same examples to specify a component set for
installation, Setup will install only the components you specified during a
Typical installation.
62 McAfee VirusScan Anti-Virus Software
41) will show only the components you specify as those available for
Description
The AutoUpdate and AutoUpgrade
utilities
Extensions that add right-click
functionality that enables you to scan
individual files
The ScreenScan utility
An applet that allows you to send virus
samples to AVERT Labs for analysis
Figure 2-8 on