McAfee VIRUSSCAN 4.5 Administrator's Manual page 45

• Run Default Scan for Viruses after Installation. This option is
active by default. The option tells Setup to finish the installation,
then to run the VirusScan application immediately afterwards to
scan your entire startup partition. The application will alert you if it
finds any viruses on this partition, but otherwise will quit without
any further notice. Clear this checkbox to skip this scan operation.
Š
NOTE: If you told Setup to remove any previous VirusScan
versions from your system, it will run the scan operation after
it restarts your computer. The VirusScan application will
appear immediately after startup.
If your computer runs Windows NT Workstation v4.0 or Windows 2000
Professional, you may not choose Scan boot record at startup, but you
may choose either of the other options. Neither Windows NT
Workstation nor Windows 2000 permit software to scan or make changes
to hard disk boot sectors or master boot records. Also, these operating
systems do not use an AUTOEXEC.BAT file for system startup.
17. When you have chosen the options you want, click Next> to continue.
If you selected the Create Emergency Disk option, the Emergency Disk
creation wizard starts immediately. To learn how to use this utility, see
"Using the Emergency Disk Creation utility" on page
After the utility creates an Emergency Disk, it will return to this point in
the Setup sequence. To bypass the Emergency Disk utility once it starts,
click Cancel when you see its first screen. Setup will display a second
configuration panel you can use to update your virus definition files or
to configure the AutoUpdate utility
Figure 2-12. Update Virus Definition Files panel
Installing VirusScan Software
47.
(Figure 2-12).
Administrator's Guide 45