Kyocera Ci1000 Technical Reference Manual page 224

Chapter 7 Emulation
E-Mask Bit Values
7-112
Table 7.38. KC-GL Instructions (Sheet 2 of 2)
Instruction Parameters
OC –
OE –
OF –
OH –
OI –
OL –
OO –
OP –
OS –
OT –
OW –
PA x1-coordinate [i/sd], y1-coordinate [i/sd] (,x2-
coordinate [i/sd], y2-coordinate [i/sd], ..., xn-
coordinate [i/sd], yn- coordinate [i/sd])
PB –
PD x1-coordinate [i/sd], y1-coordinate [i/sd]
(, ... xn-coordinate [i/sd], yn-coordinate [i/sd])
PM –
Δx1 [i/sd], Δy1 [i/sd] (,Δx2 [i/sd], Δy2 [i/sd], ...,
PR
xn-coordinate [i/sd], yn-coordinate [i/sd])
PS paper-size [i]
PT pen-thickness [d]
PU x1-coordinate [i/sd], y1-coordinate [i/sd]
(, ... xn-coordinate [i/sd], yn-coordinate [i/sd])
RA x-coordinate [i/sd], y-coordinate [i/sd]
RO angle-in-degrees [i]
Δx [i/sd], Δy [i/sd]
RR
SA –
SC Xmin [i], Xmax [i], Ymin [i], Ymax [i],
SI character-width [d], character-height [d]
SL tanθ [d]
SM character [c]
SP pen-number [i]
SR character-width [d], character-height [d]
SS –
TL tick-length-in-positive-direction [d]
(, tick-length-in-negative-direction [d])
(pen-control [i],) Δx [i], Δy (,...)
UC
(, pen-control [i]) (,...,)
WG radius [i/sd], start-angle [i], center-angle [i]
(, resolution [i])
XT –
YT –
The IM instruction sets an E-mask that controls how errors are reported on the RS-232C
interface. The E-mask value is the sum of the bit values in the following table.
Table 7.39. E-Mask Bit Values
Bit Error No. Description
1 0 1 Command not recognized
2 1 2 Wrong number of parameters
Description
Output commanded position and pen
status*
Output error*
Output factors*
Output hard-clip limits*
Output identification*
Output label length
Output options*
Output P1 and P2*
Output status byte*
Output carousel type
Output window*
Plot absolute
Print buffered label
Pen down
Polygon mode
Plot relative
Select paper size
Pen thickness
Pen up
Fill rectangle absolute
Rotate coordinate system
Fill rectangle relative
Select alternate character set
Scale
Absolute character size
Character slant
Symbol mode
Select pen
Relative character size
Select standard character set
Tick length
Plot user-defined character
Plot filled wedge
X-tick
Y-tick