Basic Setup; Altitude Adjustment; Changing The Display Language - Dell 1135 Mono Laser User Manual

Basic setup

After installation is complete, you may want to set the machine's default settings. Refer to the next section if you would
like to set or change values. This chapter gives you step-by-step instructions for setting up the machine.
This chapter includes:

Altitude adjustment

Changing the display language

Setting the date and time
Changing the clock mode
Changing the default mode
Setting sounds
Entering characters using the number keypad
Using the save modes
Setting the default tray and paper
Setting job timeout
Altitude adjustment
The print quality is affected by atmospheric pressure, which is determined by the height of the machine above sea
level. The following information will guide you on how to set your machine to the best print quality or best quality of
print.
Before you set the altitude value, determine the altitude where you are.
Ensure that you have installed the printer driver with the provided software CD.
1.
You can launch Printer Settings Utility from the Start menu, select Programs or All Programs > Dell > Dell
2.
Printers > your printer driver name > Printer Settings Utility.
Click Setting > Altitude Adjustment. Select the appropriate value from the dropdown list, and then click Apply.
3.
If your machine is connected to a network, Embedded Web Service screen appears automatically. Click
Machine Settings > System Setup > Machine Setup > Altitude Adj. Select the appropriate altitude value,
and then click Apply.
If your machine is connected via a USB cable, set the altitude in Altitude Adj. option on the machine's
display.
Changing the display language
To change the language that appears on the display, follow the steps below:
Press Menu (
1.
Press the left/right arrow until System Setup appears and press OK.
2.
Press the left/right arrow until Machine Setup appears and press OK.
) on the control panel.
High 1
1.
High 2
2.
High 3
3.
Normal
4.