Surround - Denon AVR-485S Operating Instructions Manual

ENGLISH

13 SURROUND

Before playing with the surround function
• Before playing with the surround function, be sure to use the test tones to adjust the playback level from each speakers. This adjustment can
be performed from the remote control unit, as (described) below.
• The adjustment with the test tones is only effective in the STANDARD (DOLBY/DTS SURROUND) modes.
The adjusted playback levels for the different surround modes are automatically stored in the memory of each surround modes.
1
Set the STANDARD (DOLBY/DTS SURROUND) modes.
(Main unit)
2
Press the TEST TONE button.
Test tones are output from the
different speakers. Use the channel
volume adjust buttons to adjust so
that the volume of the test tones is
the same for all the speakers.
NOTE: Please make sure the "AUDIO" position of the slide
switch on the remote control unit.
3
After completing the adjustment, press the TEST TONE button
again.
38
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
1
1
2 2
2, 3