Tool Table Usage - HEIDENHAIN ND 522 - 2-2011 User Manual

Tool Table Usage

Example: Setting a workpiece datum without using the probing
function.
Tool diameter 2.00
Tool length: 20.000
Tool unit: mm
Tool type: flat end mill
It is also possible to have the ND 522/523 determine the
length of an offset. See alternative example below.
Press the TOOL hard key.
The cursor will default to the TOOL TABLE form.
TOOL TABLE
Cursor to the tool to be defined, or enter the tool
number. Press ENTER.
TOOL DIAMETER
Enter the tool diameter (2.0mm).
Cursor down to the LENGTH field using the DOWN
ARROW key.
TOOL LENGTH
Enter the tool length (20.0mm) .
Cursor down to the UNITS field using the DOWN
ARROW key.
ND 522/523 33