Table of Contents
Advertisement
that the boards are not bending and shorting against each other. If they are, you will
need to install the PCI Extender (see previous section).
6. Replace the cover on the computer.
cover.
Connect the LDI-12T Interface to Audio Sources
Cables/Connections
1. Use only the proprietary Lexicon cable (provided) to connect the Core-32 card to the
LDI-12T Interface.
2. With both the computer and the LDI-12T powered down, attach the cable between the
lower connector on the back of the Core-32 card and the Computer port on the LDI-12T
rear panel.
3. Connect the 9V connector to the AC Power port on the rear panel of the LDI-12T, and
plug the other end into a wall socket.
The LDI-12T supports various formats of analog and digital I/O. Make certain your cables
are the correct types prior to connection. (Analog XLR connectors are +4dBu balanced [Pin
2 hot], analog RCA connectors are -10dBV unbalanced). To select a source for input or
output within the application software, refer to the documentation provided with your
particular software package.
Software Installation
Install Supported Third Party Audio Software
Lexicon Studio requires compatible front-end software (such as Steinberg Cubase Audio
VST) to operate. Please refer to your particular software installation guide for assistance. As
Lexicon Studio installs software within directories of your front-end software, you should
install your audio software first (even prior to installing your Lexicon Studio hardware) and
verify that it launches properly before installing Lexicon Studio (even though it will not be
audio-capable until installation of the Lexicon Studio system).
Install the ASIO Lexicon Studio Driver for Windows 95
1. With your Lexicon hardware and Cubase VST software installed, power up your
computer and your LDI-12T interface. Once your computer is fully booted, Windows 95
will identify your Core-32 as a new PCI multimedia device (in the event of booting
problems, refer to the troubleshooting section of your Lexicon Studio manual).
2. Insert Lexicon Studio Software Disk 1: Studio Drivers, and click the Next > button.
3. Windows will find the driver information for the Lexicon Studio Sound System. Click
the Finish button to install the drivers.
4. Windows will prompt you to restart your computer once it is finished loading the drivers. If
you are also installing a PC-90, you should choose not to restart at this time and
continue by following the instructions for installing PC-90 software within the next
section. Windows will prompt you twice to restart. Select No at both prompts and move
on to the next section, Installing the PC-90 Software for Windows 95. If you are only
installing Core-32 drivers, you may now restart your machine.
Do not operate the system without the
6.
Lexicon Studio User Guide Addendum
Advertisement
Table of Contents
