Hardware Installation - Lexicon STUDIO - ADDENDUM Manual

Hardware Installation

Windows will automatically detect and recognize your Lexicon Studio hardware once
installed and allowed to restart. Windows 95 will also prompt you to install drivers at this
point. Some of the Lexicon Studio software is installed within directories of your audio
control software (such as Cubase Audio VST). You should install your audio software first
and verify that it launches properly before installing Lexicon Studio (even though it will not
be audio-capable until installation of the Lexicon Studio system). Please refer to your audio
software manual for details on installation, and then continue the Lexicon Studio hardware
and software installation.
Setup
1. Put on the anti-static wrist strap.
2. Place the foam from your Lexicon Studio package on top of a work surface next to your
computer. (Any piece of static-safe foam with similar dimensions to the Core-32 card can
be used).
3. Make sure that your computer is properly shut down and unplugged.
4. Remove the computer top cover and PCI slot cover(s) for the slot(s) that you've chosen
for your Core-32 cards. If you do not know how to open your computer, consult your
computer's owner manual.
5. Touch the computer power supply case to discharge any personal static electricity.
6. Remove the Core-32 card from its anti-static bag, holding the card only by its edges. Be
careful to avoid touching the pins on the bottom edge of the card. Place the Core-32 bag
on top of the foam and place the card on the foam with the white PC-90 connector facing
up as shown below.
Mount the PC-90 card onto the Core-32 card
The PC-90 module can only be mounted onto a Lexicon Studio Core-32 system card.
Attempting to attach your PC-90 to any other type of PCI card may damage your PC-90
module.
1. Touch the computer power supply case to discharge any personal static electricity.
2. Remove the PC-90 module from its anti-static bag, holding the card only by its edges.
Place the bag on your work surface next to your computer and place the PC-90 on it with
its white connector facing up.
3. Pick up the PC-90 card and orient it so that the connector side faces away from the palm
of your hand.
4.
Lexicon Studio User Guide Addendum