Alamo Interstater TS-100A, TS-115A, TS-125A, TS-135A Assembly Instruction Manual page 49

Wing Cut Off Switch: (continued)
10.
Connect Tilt Cylinder to Mower Deck. The Tilt
Cylinder connects to the mower head (See Figure 15
& 16). Note you will need to remove the belt guard to
connect this cylinder so you will have room for the
cylinder mounting pin to be installed (See Figure 16).
When connecting the cylinder the grease fitting on the
rod end must face up, the locking collar on the cylinder
must face up and be tightened on rod end. The RH
Wing and the LH Wing will mount the same. Install the
RH wing the same as the LH wing . Reinstall Belt
Guard.
11.
Install Wire Harness to Motor Solenoid. The
thumb nut on top of the solenoid will allow the solenoid
to be turned to different direction if needed. (See
Figure 17 & 21)
Wire Harness to
Magnetic Swithc
Figure 14
RH Wing Shown From Rear
Figure 16
Interstater (NH TS-100A , 115A , 125A & 135A Asy. Manual) 06/04
© 2004 Alamo Group Inc.
Wing Mower Installation
Wire Harness to
Motor
LH Wing Shown
From Rear
Page 7 - 5
LH Wing Shown
Figure 13
LH Wing Shown From Front
Clevis Locking
Collar
Cylinder Pin
Figure 15
Soleniod
Figure 17
From Rear
Cylinder Rod
Clevis with grease
fitting up
Wire Harness