Alamo Interstater TS-100A, TS-115A, TS-125A, TS-135A Assembly Instruction Manual page 46

Wing Cut Off Switch:
1.
Assemble Brackets & Magnetic Switches.
Locate the Magnetic switch mounting bracket,
dual wings there will be two of these (See Figure
1). If Dual wings the two brackets will have the
switches mounted on the opposite side (See
Figure 2). Once these have the switches bolted on
lay the brackets aside for now. (See Figure 20)
2.
Assemble Magnetic Switch Activators. This
magnetic switch activator has a magnet inside
and a cover that must be installed (See Figure 4).
There are brackets that these bolt to. With dual
wings there is a LH and RH bracket. Bolt the
Magnetic activators to the brackets (See Figure 5)
LH Bracket Shown). Note there are two sets of
mounting holes. In figure 5 the set that have the
bolts through them is used to shut wing off at 45
degree up. If the other set of holes are used wing
mower will shut off at 90 degrees up. The 45
degree setting is recommended for standard ap-
plications.
3.
Install Switch Brackets & Head Mounting
Brackets. Use a hoist to lift the Wing Mower and
position it for mounting. DO NOT get under Mower
while lifted on a hoist (See Figure 6). Mower is only
be positions so that switch brackets and hinge
brackets can be installed to head, this must be
done before mower can be mounted to lift frame.
LH Wing Magnetic
Switch & Bracket
Figure 3
Interstater (NH TS-100A , 115A , 125A & 135A Asy. Manual) 06/04
© 2004 Alamo Group Inc.
Wing Mower Installation
RH Wing Magnetic
Switch & Bracket
Page 7 - 2
Small Screw Hole
Slotted Hole for
switch wires
Small Screw Hole
Figure 1
Switch
Mounting
Screw
Figure 2
Magnetic
Stich
Activator
Case
Cover
Figure 4
Bracket
Mounting
Holes
Magnetic
Switch
Magnetic Switch
Wire Plug
Magnet
Inside