Alamo Interstater TS-100A, TS-115A, TS-125A, TS-135A Assembly Instruction Manual page 47

Wing Cut Off Switch: (continued)
4.
Install Mower Rear Mounting Brackets &
Magnetic Switches. The Mower Hinge Link has a
LH & RH (See Figure 7). These brackets will slide
over the Hinge Pin which is bolted to the mower
deck at the factory. There are two Threaded holes
in the end of the hinge pin (See Figure 7) These
two holes serve dual purpose. First they hole the
hinge bracket on and the Magnetic Activator Bracket
on. Some times you will need to loosen the Hinge
pin to align the two holes so the bracket will bolt on.
(See Figure 8 & 9). Tighten the two mounting bolts
in to the hinge pin. The Hinge bracket will still turn
free.
Figure 6
Magnetic Activator
Switch Bracket
Figure 8
Interstater (NH TS-100A , 115A , 125A & 135A Asy. Manual) 06/04
© 2004 Alamo Group Inc.
Wing Mower Installation
Always use overhead
hoist to position mower
deck
LH Wing Shown
From Rear
Hinge Pin
Bracket
Page 7 - 3
Mount Magnet Activator to
these hole for 45 degree
RH
Bracket
Shown.
Mount Magnet Activator to
these hole for 90 degree
Figure 5
LH Wing Shown
Figure 7
RH Wing Shown
From Rear
Magnetic Activator
Switch Bracket
Hinge Pin
Bracket
Figure 9
shut off.
shut off.
LH Wing
Rear Hinge
Bracket
Two
Threaded
Holes in
Hinge Pin