Preparing For Installation - D-Link DCS-6511 User Manual

Hd day & night vandal-proof fixed dome network camera

Hide thumbs Also See for DCS-6511:

Table of Contents

Section 2 - Installation

A. Depending on how you choose to mount the camera, you may need to change the

orientation of the cable. For instance, when using the Surface Mounting Bracket, the

cables may need to exit through the side of the camera base rather than the top.

Changing Cable Orientation:

1. Disassemble the camera enclosure. (See Figure A on page 6.)

2. Loosen, but do not remove, the two screws that secure the camera bracket to the

base of the enclosure using a screwdriver. (Figure 1.1)

3. Slide the camera bracket towards the front of the camera base. (Figure 1.2)

4. Lift the camera bracket up and off from the camera base. (Figure 1.3)

5. Disconnect the cables from the connectors at the base of the camera.

6. Place the cable into the new hole and reconnect the cables to the cable connectors

at the base of the camera. (Figure 1.4)

D-Link DCS-6511 User Manual

Preparing for Installation

Figure 1.1

Figure 1.2

Table of Contents