Bent Mount (Dcs-34-3) - D-Link DCS-6511 User Manual

Section 2 - Installation
1. Attach the mounting plate to the bracket cap using the three screws as shown
in Figure 4.1.
2. Locate a suitable position on the ceiling for a 34 mm (+2 / –0 mm) hole to be
cut. A template is included to aid in marking the mounting hole.
3. Cut the hole in the ceiling according to the template
4. Drill 4 separate 6 mm holes corresponding to the holes in the mounting
template and insert the plastic anchors into these holes.
5. Place the rubber seal between the bent bracket and the ceiling to ensure a
waterproof seal between the ceiling and the bracket. (Figure 4.2)
6. Attach the pendant bracket to the ceiling using the screws provided.
7. Attach the bracket cap to the bottom of the bent bracket, rotating the cap
counter-clockwise to tighten it into place.
8. Insert the screw into the base of the bent bracket at the top of the bracket cap
to secure the bracket cap into place.
9. Connect the Ethernet cable and the power cable and thread them through the
pendant bracket.
D-Link DCS-6511 User Manual

Bent Mount (DCS-34-3)

Mounting
Plate
Figure 4.1
Bent
Bracket
Figure 4.2
Bracket
Cap
Bracket
Cap
18