Preparing For Installation - D-Link DCS-6510 User Manual

Installation
A. Depending on how you choose to mount the camera,
you may need to change the orientation of the cable. For
instance, when using the Surface Mounting Bracket, the
cables may need to exit through the side of the camera
base rather than the top.
Changing Cable Orientation:
1. Disassemble the camera enclosure. (See Figure A.
on page 6.)
2. Loosen, but do not remove, the two screws that
secure the camera bracket to the base of the
enclosure using a screwdriver. (Figure 1.)
3. Slide the camera bracket towards the front of the
camera base. (Figure 2.)
4. Lift the camera bracket off of the base and out of the
way. (Figure 3.)
5. Disconnect the cables from the circuit board at the
base of the camera. (Figure 4.)
D-Link DCS-6510 User Manual

Preparing for Installation

Figure 1.
Figure 3.
Figure 2.
Figure 4.
8