Installation - NETGEAR WAG511 - 802.11a/b/g Dual Band Wireless PC Card User Manual

NETGEAR Dual Band Wireless PC Card 32-bit CardBus WAG511 User Manual
Your WAG511 Wireless PC Card factory default basic settings are:
• Network Name Service Set Identification (SSID): ANY
Note: In order for the WAG511 Wireless PC Card to communicate with a wireless
access point or wireless adapter, all devices must be set up to use the same
wireless network name (SSID).
• Network Mode (Infrastructure or Ad-hoc): Infrastructure
• Data security WEP, WPA2-PSK, or WPA-PSK encryption: Disabled
The section below provides instructions for setting up the WAG511 Wireless PC Card for basic
wireless connectivity to an access point.

Installation

This chapter explains how to install the WAG511 to connect to a network with an access point or
router. For wireless security and advanced settings,
Wireless Security".
To install the WAG511 Wireless PC Card:
1. First, install the WAG511 software.
a. Insert the NETGEAR CD. If the CD main page does not appear, double click Autorun.exe
on the CD.
b. Click Install Driver & Utility.
Figure 1-1
Chapter 2, "Network Connections and
v4.0, March 2007
1-3