Specifications - Denon RCD-CX1 Owner's Manual

GTunerH
Symptom Cause
Buzzing noise in • The antenna cable is not properly
FM broadcasts. connected.
• Noise interference from a nearby
electronic device equipped with
a microprocessor, or the radio
broadcast signal is weak.
Hissing or buzzing • Noise interference
noise is heard in nearby monitor, etc., or there
AM broadcasts. is interference in the broadcast
signal.
Humming noise • There is interference from current
is heard in AM in power cords.
broadcasts.
GRecord PlayerH
Symptom Cause
When playing • The player and speakers are too
records, a wailing close together.
noise (howling) is • The floor is soft and vibrates
produced when easily.
the volume is
raised.
GiPodH
Symptom Cause
iPod cannot be • Device you want to play and set
played. input source do not match.
• Cable is not properly connected.
• Control dock for iPod's AC
adapter is not connected to
power outlet.
GRemote Control UnitH
Symptom Cause
Set does not work • Batteries are worn.
properly when • You are operating outside of the
remote control specified range.
unit operated. • Obstacle between main unit and
remote control unit.
• The batteries are not inserted in
the proper direction, as indicated
by the polarity marks in the
battery compartment.
• The set's remote control sensor
is exposed to strong light (direct
sunlight, inverter type fluorescent
bulb light, etc.).
Countermeasure
• Connect the antenna properly.
• Reposition the equipment or the
positions or directions of the
connection cables, antenna, etc.
• Connect an outdoor antenna.
from a • Turn off the monitor.
• Change the position or direction
of the AM loop antenna.
• Connect an outdoor antenna.
• Connect an outdoor antenna.
Countermeasure
• Move the player and speakers as
far apart as possible.
• Use cushions or spikes to absorb
the vibrations of the speakers
being conveyed from the floor.
Countermeasure
• Select an appropriate input
source.
• Reconnect.
• Plug the control dock for iPod's
AC adapter into a power outlet.
Countermeasure
• Replace with new batteries.
• Operate within the specified
range.
• Remove the obstacle.
• Insert the batteries in the
proper direction, following the
polarity marks in the battery
compartment.
• Move the set to a place in which
the remote control sensor will
not be exposed to strong light.

Specifications

Page
10
n
Receiver section
–
Rated output:
–
High frequency distortion:
–
Output terminals:
–
Equalizer amplifier output
–
(REC OUT terminals):
Input sensitivity / Input impedance:
–
RIAA deviation:
Reception frequency range:
Reception sensitivity:
Page
FM channel separation:
–
FM S/N ratio:
FM harmonic distortion:
–
S/N ratio:
(A-weighted network):
Tone control:
Frequency response:
Page
18 n
Clock/Timer section
Clock type:
9
Timer:
–
n
CD section
• Analog output
Signal type:
Sampling frequency:
Page
Usable discs:
4
• Digital output
4
Optical:
Emission wavelength:
4
n
General
Power supply:
4
Power consumption:
Maximum external dimensions:
Weight:
4
n
Remote control unit (RC-1109)
Remote control method:
Batteries:
Maximum external dimensions:
Weight:
z For purposes of improvement, specifications and design are subject to change without notice.
2-channel driving
37 .5 W + 37 .5 W (8 Ω/ohms, DIN, 1 kHz, T.H.D. 0.7 %)
75 W + 75 W (4 Ω/ohms, DIN, 1 kHz, T.H.D. 0.7 %)
0.05 % (Rated output: –3 dB), 8 Ω/ohms, 1 kHz
Speaker 4 ~ 16 Ω/ohms
Suited for headphones/stereo headphones
Rated output : 150 mV
PHONO (MM) : 2.5 mV / 47 kΩ/kohms
PHONO (MC) : 0.2 mV / 100 Ω/ohms
CD, LINE1, LINE2 : 130 mV / 47 kΩ/kohms
PHONO (MM) : 20 Hz ~ 20 kHz ±0.5 dB
PHONO (MC) : 30 Hz ~ 20 kHz ±0.5 dB
FM : 87 .5 MHz ~ 107 .9 MHz AM : 520 kHz ~ 1710 kHz
FM : 1.5 μV / 75 Ω/ohms AM : 20 μV
35 dB (1 kHz)
Monaural : 74 dB Stereo : 70 dB
Monaural : 0.3 % Stereo : 0.4 %
PHONO (MM) : 84 dB
(With input terminals short-circuited, 5 mV input signal)
PHONO (MC) : 70 dB
(With input terminals short-circuited, 0.5 mV input signal)
LINE1, LINE2 : 95 dB (input terminals short-circuited)
BASS : 100 Hz ± 8 dB
TREBLE : 10 kHz ± 8 dB
10 Hz ~ 40 kHz (+0.5 dB, –3 dB) (INPUT: LINE1, PURE DIRECT: ON)
Power line frequency synchronized method (Within ±60 seconds per month)
Everyday timer / Once timer : One system each
Sleep timer : Max. 90 minutes
[Super Audio CD] [CD]
1-bit DSD 16-bit linear PCM
2.822 MHz 44.1 kHz
Super Audio CD Compact Disc
– –15 ~ –21 dBm
– 660 nm
AC 120 V, 60 Hz
50 W
0.3 W (Standby)
300 (W) x 110 (H) x 341 (D) mm
8.0 kg
Infrared pulse method
R03/AAA Type (two batteries)
44 (W) x 233 (H) x 22 (D) mm
165 g (including batteries)
ENGLISH