Connections To Other Devices; Antenna Terminals; Connecting The Power Cord; Once Connections Are Completed - Denon RCD-CX1 Owner's Manual

Connections to Other Devices

Antenna terminals

AM / FM
The AM and FM reception sensitivity depends on the place the antenna
is set and the direction in which it is set. Set it so that reception is
best.
AM loop
FM indoor antenna
antenna
(supplied)
n Connecting the AM loop antenna
1
NOTE
Push the lever.
• Make sure the AM loop
antenna lead terminals
2
do not touch metal parts
Insert the conductor.
of the panel.
• Do not connect two FM
antennas simultaneously.
3
Return the lever.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's
attention to Article 820-40 of the NEC which provides guidelines
for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building,
as close to the point of cable entry as practical.

Connecting the Power Cord

Wait until all connections have been completed before connecting the power cord.
(supplied)
NOTE
• Insert the AC plugs securely. Incomplete connections could cause noise.
• When the power cord is plugged into the power outlet, the power indicator flashes orange for about 10 seconds.
Do not unplug the power cord before the power indicator turns off and the RCD-CX1 enters Standby mode.
• Only use the supplied power cord.
• Be sure the power cord is unplugged from the power outlet before connecting or disconnecting it to the AC IN.

Once Connections are Completed

Turning the Power On
(vpage 12)
To household
power outlet
(AC 120 V, 60 Hz)
Power cord
(supplied)
ENGLISH
0