Lexicon 300 - V3.0 REV 1 Owner's Manual page 40

To enter Setup Select mode, simply press the front-panel key labeled SETUP
SELECT. This mode has two pages of controls:
Page One:
S
E A
Page One allows selection of a setup. The upper line indicates "S:" (setup), a
preset (P)or register (R) number, and the setup name. The upper row of buttons
will step sequentially through the list of setups; turning the soft knob will scroll
through the list. After finding a setup you want to load, note its number. There are
two ways to load this setup:
Simply press ENTER while the number of the setup you want is selected on the
display. If this is not the current setup, the number will flash on the display. If you
do not press ENTER within a few seconds, the display will automatically change
back to the current setup. Pressing ENTER once the display has changed will
still load the selected setup.
Enter the setup number you want on the numeric keypad to select a setup. Press
ENTER to load the setup.
Page Two:
This page displays the current Soft knob parameter value, as well as the Setup
parameters which are patched to it.
Page Three:
This page displays the current Soft knob parameter value, as well as the Effect
parameters which are patched to it.
: P101 Large Hall
:P101 Large Hall
or
KnobPatchS: _ _ 0
Dst1 : Dst2 :
KnobPatchA/B: _ _ 0
Dst1 :Dst2 Dst 3 Dst 4 :
System Operation
Setup Select
3-11