Lexicon 300 - V3.0 REV 1 Owner's Manual page 100

Hide thumbs Also See for 300 - V3.0 REV 1:
Table of Contents

Advertisement

300 V 3.0 Owner's Manual
P208
DM: *Pch/Pch
EA:803 *Up Shift
A true Dual-Mono pitch preset. Going to the Soft knob parameter location (in Setup Select mode) will enable you to advance
the delay parameter in the Machine A effect.
MchA
EA:803 *Up Shift Up Shift is a sweet sounding microshift up +7cents. There is a slight "chorus edge" due to a
modest amount feedback around a 0ms delay line. The Soft knob controls the delay line length.
MchB
EP:806 Echo Down 14 cents down with a 258ms recirculating delay line. This effect works great either before or
after a Reverb preset (in a Cascade Setup).
P209
DM: Pch/Comp
EA:810 Vocal Shift
Send a vocal track into the left input and send a mono prefade drum premix into the right input.
MchA
EA:810 Vocal Shift This preset combines a short delay line recirculating around a -7 cent pitch shifter.
MchB
EB:902 DrumComp 3:1 This is a bit more agressive, with 7dB of boost below the selected threshold. A quick
release of 58ms snaps up the volume. As with all compressor presets, Threshold is the critical parameter.
P210
DM: Comp/Comp
EA:901 EZ Comp
This is a true "Dual Mono" Setup. Any audio (analog or digital) should be sent pre-fade or inserted in a patch point.
MchA
EA:901 EZ Comp 2:1 A nice preset to add to an overall mix. You may need to adjust Threshold to make it work
for the particular signal you're feeding it. The release parameter is set to gently fall away after 363ms.
MchB
EB:902 DrumComp 3:1 This is a bit more agressive, with 7dB of boost below the selected threshold. A quick
release of 58ms snaps up the volume. As with all compressor presets, Threshold is the critical parameter.
P211
DM:Slow Spin
EA:607 LFO:FazeDlys
The LFO is set to 0.90Hz with a Triangle waveform, and is attached to both Machine Flange Glide Delays. Turning the LFO
faster will speed things up, but may cause Machine A to pitch too heavily. This preset can be used with either mono or stereo
sources, but discrete echoes will appear at the left output.
MchA
EP:607 LFO:FazeDlys Faze Dlys makes use of the LFO to the Flange Glide Delay (FDLY). The base delays are
set in different time domains: one side at 1.9ms with a feedforward gain; the other at 5.6 with a negative feed gain. As the
Glide passes over each base delay, the phase of each gain is changed. In between, the output is a mixture of each. A great
effect on a ripping guitar solo.
MchB
EP609 Chorus This preset makes use of a small variation in the glide delay to modulate the sound. The glide moves
between 9.7ms and 11.8ms. Advancing the LFO to values near 1.50Hz to 2.0 Hz yields a nice chorusing effect. There are
no other delay lines, but the output lines are channel-swapped such that the left input passes to the right output and vice-
versa. In a Dual Mono Setup, this is ,of course, inaudible.
5-8
EB:806 Echo Down
EB:902 DrumComp3:1
EB:902 DrumComp 3:1
EB:609 Chorus
Lexicon

Advertisement

Table of Contents
loading

This manual is also suitable for:

300 v 3.0

Table of Contents