Selecting The Keyer Operating Mode - Yaesu FT-950 Operating Manual

The configuration of the Electronic Keyer may be customized independently for the front and rear KEY jacks of the
FT-950. This permits utilization of Automatic Character Spacing (ACS), if desired. This permits the use of an
electronic keyer via the front jack and a straight key or computer-driven keying line via the rear panel jack.
1. Press the [ MENU ] button to enter the Menu mode.
2. Rotate the [ SELECT ] knob to select Menu item
"037 A1A F-TYPE 037 A1A F-TYPE" (for the front KEY jack) or
037 A1A F-TYPE 037 A1A F-TYPE 037 A1A F-TYPE
"039 A1A R-TYPE 039 A1A R-TYPE" (for the rear-panel KEY jack).
039 A1A R-TYPE 039 A1A R-TYPE 039 A1A R-TYPE
A :
DVICE
Press the [ SELECT ] knob momentarily to toggle
the Menu item display between "037 A1A
"F-TYPE F-TYPE" or "039 A1A 039 A1A" and "R-TYPE
F-TYPE F-TYPE 039 A1A 039 A1A
F-TYPE 039 A1A
3. Rotate the [ CLAR/VFO-B ] knob to set the keyer
to the desired mode. The available selections are:
OFF: The built-in Electronic Keyer is turned off
OFF OFF
OFF OFF
("straight key" mode).
buG: Dots will be generated automatically by the
buG buG
buG buG
keyer, but dashes must be sent manually.
ELE: Both dots and dashes will be generated auto-
ELE ELE ELE ELE
matically when you use your paddle.
ACS: Same as "ELE ELE" except that the spacing be-
ACS ACS ACS ACS ELE ELE ELE
tween characters is precisely set by the keyer
to be the same length as a dash (three dots in
length)
4. When you are finished, press and hold in the
[ MENU ] button for one second to save the new
setting and exit to normal operation.
FT-950 O
PERATING
U B
SING THE UILT

Selecting the Keyer Operating Mode

037 A1A" and
037 A1A 037 A1A 037 A1A
R-TYPE". R-TYPE R-TYPE
R-TYPE
M
ANUAL
CW M
ODE
- E K
IN LECTRONIC
[ SELECT ] Knob
ACS "OFF"
Morse
"E" & "T"
ACS "ON"
Morse
"E" & "T"
O
PERATION
EYER
[ MENU ] Button [ CLAR/VFO-B ] Knob
Inter-character
spacing to short
Page 73