Cleaning Discs; About The Remote Control Unit; Inserting The Batteries; Operating Range Of The Remote Control Unit - Denon CHR-F103 Operating Instructions Manual

Cleaning discs

• If there are fingerprints or dirt on discs, wipe them off before using
the disc. If not the sound quality could be reduced and the sound
may be broken.
• Use a commercially available disc cleaning set or a soft cloth to clean
discs.
Do not wipe with a circular motion.
Gently wipe the disc from the
inside towards the outside.
NOTE:
• Do not use record spray, antistatic agents, or benzene, thinner or
other solvents.

About the remote control unit

The included remote control unit (RC-1042) can be used to operate
not only the CHR-F103 but also other components in the F102 series
( page 32).
NOTE:
• The system remote control unit included with the receiver (DRA-
F102/F102DAB) cannot be used to operate the CHR-F103. Use
the remote control unit included with the CHR-F103.

Inserting the batteries

q Remove the remote control w Set two R6P/AA batteries in
unit's rear cover. the battery compartment in
the indicated direction.
e Put the rear cover back on.
Notes on batteries:
• Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated nearby the unit.
(The attached batteries are only for verifying operation.)
• When inserting the batteries, be sure to do so in the proper
direction, following the "<" and ">" marks in the battery
compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries
in flames.
• If the battery fluid should leak, carefully wipe the fluid off the
inside of the battery compartment and insert new batteries.
• Remove the batteries from the remote if it will not be in use for
long periods.
5
ENGLISH

Operating range of the remote control unit

• Point the remote control unit at the remote sensor when operating
it.
• When used connected to other components in the F102 series,
point the remote control unit at the remote control sensor of the
receiver (DRA-F102/F102DAB) when operating it.
• The remote control unit can be used from a distance of up to about
7 meters, at a horizontal angle of up to 30° with respect to the
sensor.
30°
30°
Approx. 7 m
NOTE:
• The set may function improperly or the remote control unit may
not operate if the remote control sensor is exposed to direct
sunlight, strong artificial light from an inverter type fluorescent
lamp or infrared light.
ENGLISH