Ac Power Source Operation; Ac Input Voltage Selection (U.s.a. Users Only) - Yaesu FT-897D Operating Manual

AC power source operation

For base station installations, Yaesu recommends the use of
the FP-30 AC power supply, which is designed to clamp
onto the FT-897D.
Installation
1. Turn the transceiver's power off, and disconnect all
cables from the transceiver.
2. Remove the six screws (three screws on bottom side and
rear side), then lift off the bottom cover (Figure 1 and 2).
3. Attach the FP-30 to the bottom of the FT-897D, then
affix it in place with the six screws removed in the above
steps (Figure 3).
4. Connect the 6-pin Molex plug from the FP-30 to the
INPUT jack on the rear panel of the FT-897D (Figure
4).
5. Make sure that your AC voltage is correct and that the
FP-30 POWER switch is set to Off; connect the AC
power cable between the INPUT jack on the rear panel
of the FP-30 and a nearby AC wall outlet.
Figure 1
Figure 2
Ì Before moving the AC range switch, disconnect the FP-30's AC Power
Cable from the AC line outlet, then wait 10 minutes to allow the power
supply's electrolytic capacitors to discharge (electrical shock hazard!).
Ì Peel off the label on the side of the FP-30.
Ì Move the AC range switch to the "115" position for operation from
100-120 VAC, or to the "230" position for operation from 200-240 VAC.
Ì Always uses the 10 A Fuse in the fuse holder on the rear panel whether
operate on 100-120 VAC or 200-240 VAC. Do not use the improper
fuse.
Warning: Our Warranty does not cover damage caused by improper supply voltage nor use of an improper fuse.
FT-897D O M
P
OWER
(requires optional FP-30 AC power supply)

AC Input Voltage Selection (U.S.A. Users only)

C
ONNECTIONS
Operation
1. To turn the transceiver on, turn on the POWER switch
on the FP-30 before turning on the POWER switch on
the FT-897D.
2. To turn the transceiver off, turn off the POWER switch
on the FT-897D before turning off the POWER switch
on the FP-30.
When you do not use the FP-30 with the FT-897D
for a long time, disconnect the AC plug from the AC
wall outlet.
Figure 4
I
NSTALLATION
Figure 3
POWER Switch
Peel off the label
Page 5